Clearwater Beach, Island Estates, Sand Key and up through Dunedin. Gulf-side boats take the hardest salt exposure in the bay area — we clean at your slip and prove it with photos.
We photograph all four sides before we start and again when we finish. The photos are time-stamped and logged to your boat’s record — so you can see exactly what was done, whether you were aboard or not.
Paul Capobianco — founder of Deckhand, based in Tampa Bay. Every job is documented and logged to your vessel’s record.
Clearwater Harbor and the Intracoastal put boats a short run from open Gulf water. That access is the appeal, and it is also why these hulls need the most attention.
Local water and weather decide how often a boat needs attention. Here is what we see on Clearwater boats.
Direct Gulf access means full-strength salt spray on every run. It dries fast in the sun and leaves a haze that bonds to gelcoat, canvas and isinglass.
Beach-adjacent slips mean fine sand works into nonskid, track hardware and upholstery seams. It is abrasive, and a pressure rinse drives it deeper rather than removing it.
Open western water and no shade means more UV. Oxidized gelcoat and chalking show up sooner on Clearwater boats than on protected bayside hulls.
Every service is priced per foot, so you know the number before we start. A 25-foot full detail is $700. Payment is held securely until the work is photo-verified.
Full detail covers the exterior. With the boat in the water we work by hand only — no electrical or rotary tools, for safety reasons when working over water. Wax and polish are applied by hand, and no compounding is performed. We service vessels up to 36 feet.
We come to your slip, lift or private dock. If you are on the water anywhere in this area, we can reach you.
Yes. Clearwater Beach, Island Estates, Sand Key, Belleair and the Clearwater Municipal Marina are all in our regular route, and we run north to Dunedin and Safety Harbor.
Yes. Every mate must carry general liability insurance of at least $1,000,000 per occurrence before they can accept a single job. We review the certificate of insurance by hand, and we re-check it when it expires — a lapsed policy takes the mate off the job board until it is current again. Mates also pass government ID verification and sign a contractor agreement.
No. You do not need to be present. We work at your slip whether you are aboard or not, and we document all four sides of the vessel before and after. Those before-and-after photos are time-stamped and logged to your boat's record, so you can see exactly what was done from anywhere.
In practice, yes. Gulf-side boats carry a heavier salt load and more sun exposure, so gelcoat protection matters more and the interval between details is usually shorter.
A full detail covers the full exterior — hull and topsides, glass and isinglass, and nonskid. With the boat in the water we work by hand only: no electrical or rotary tools, for safety reasons when working over water, so wax and polish are applied by hand and no compounding is performed. It is $28 per foot, and every job is documented with before-and-after photos of all four sides.
Tell us your slip and your boat length and we will get you a price today.